Avery Dennison Pathfinder 6140 User Manual download pdf (Page 20)

2-6 LNT Programmer’s Manual

Adjusting the Supply Position

A non-print zone exists on this printer of 0.20 inches on the leading edge of the supply. The

leading edge is the edge that exits the printer first.

You can adjust the supply position to a negative setting (use backfeed) to reduce the size of

the non-print zone to 0.01 inches when using Peel mode. The adjustments are in steps

(0.00333 inch). The default value is 0.

Note: Using a negative supply position may increase the possibility of a label jam.

Setting a Negative Supply Position (Using Backfeed)

Using a negative supply position enables backfeed, so the printer must be set for Peel mode.

The minimum feed length in peel mode is 0.785 inches. Using a negative supply position may

increase the possibility of a label jam.

To adjust the supply position to a negative value:

1. Turn on the printer.

2. Touch the Home key.

3. Select Printer Config and then Print Position.

4. Touch the left arrow to decrease the Supply Position.

Start with a value of -60 and then adjust if necessary.

Note: Supply Position and Overfeed Distance are in steps; the Print Margin adjustment is in

pixels (0.00049 inch). One pixel is equivalent to one dot.

5. Touch OK when finished.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

No comments

Avery Dennison Pathfinder 6140 User Manual Page 20