User / Service Manual Cutter
11/07 Rev. 2.07 10
Initialise or activate option
• after you have mounted the option correctly to the printer - and the necessary adjustment –
the option can be activated
• this can be done by changing the parameter in the firmware
• switch on the unit display shows OFF
• press FEED and CUT at the display shows INFO
same time
• press CUT until display shows SYSP
• press ENTER display shows EMUL
• press CUT until display shows PEPH
• select until display shows KNIF
• press ENTER to accept beep
• press FEED and CUT display shows SYSP
• press FEED and CUT display shows OFF
Attention: The option is now activated - all other option are deactivated!
Never touch the running blade!
Comments to this Manuals