User / Service Manual Cutter
11/07 Rev. 2.07 19
Chapter 6 Others
Media specification
The cutter blade cuts self-adhesive, cardboard and synthetic materials up to 240 g/m
2
and a
material thickness of 0.9 mm, according to the approvals in the printer specifications.
EXCEPTIONS:
- 8" wide cutters are only approved for materials up to 160 g/m
2
.
- Fiber strengthened materials (e.g. Tyvek) are not subject of the approval.
Status messages
• status messages show on the display the reason for a mail function if this is possible
• you will find following the possible reason for a cutter mail function
ST 04 stacker full
Action: - empty stacker
- (ON/OFF) key - job is further processed
ST 05 media is not more in the gap sensor
from version 1.15 for TTX 650
1.0 for TTX 450/950
Action: Check the length inside your format
press ON/OFF to accept the message
ST 07 foil end
WITH THERMAL PRINT
Action: Make sure that program point ‘FMOD’ is set to ‘NO’
depress (FEED) key display ‘OFF’
disconnect FOIL END RECOGNITION parameter: FMOD
depress (ON/OFF) key display ‘ON’ job is further processed;
punch is activated new
Comments to this Manuals