Avery Dennison AP5.4 Gen II User Manual download pdf (Page 26)

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications

AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000

Printer setup

1. Insert the WLAN CF card into the printers card slot. Switch the printer on.

In the printer menu INTERF. PARAM. > NETWORK PARAM., additional parame-

ters for WLAN operation show up.

The LED at the card is flashing as long as the card is not logged in at the

access point.

2. Make the following settings in the INTERF. PARAM. > NETWORK PARAM. menu:

3. Set parameter INTERF. PARAM. > EASYPLUGINTERPR > Interface to

„LPD Server“.

4. Restart printer to activate the settings.

Connecting

1. Connect the access point to the PC using a crossed link cable. Connect

the access point to the mains supply and switch it on.

2. Check, if the LED at the WLAN CF card lights up permanent. If it does not,

check the following points:

– Is the card plugged firmly into the card slot?

– Does the card match one of the supported card types?

– Is the parameter INTERF. PARAM. > NETWORK PARAM. > WLAN SSID set to

„idt“ (small letters!)?

CAUTION! - Network manipulations can disturb or avoid proper network

operation.

« Before connecting any device to a network, always ensure the approval of

the network administrator.

Parameter Setting Note

IP addressassign Fixed IP address

IP address

e. g.

192.168.000.999

ask the network administrator

for it; the initial three bytes must

equal the PC address

Net mask 255.255.255.000 = default setting

WLAN SSID idt use lower case letters

WLAN WEP disabled

WLAN default key 0 or any other setting

FTP server arbitrary setting

WEB Server arbitrary setting

[Tab. 21] Required parameter settings in the printer menu.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

No comments

Avery Dennison AP5.4 Gen II User Manual Page 26