Avery Dennison AP5.4 Gen II User Manual download pdf (Page 6)

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications

AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000

For detailed information on connecting a signal source see (Tab. 3):

Light barrier (64-xx Dispenser type M and AP 5.4/5.6 Dispenser only) This printer type is

shipped with a short dispensing edge [4B] with a light barrier, which serves as

signal source. After printing and dispensing, the label blocks the light barrier

and stopps the printer until the label is taken off. As soon as the light barrier is

clear again, the next label is printed.

« Connect the light barrier to the D-Sub connector at the printer front side

[4A].

[4] AP 5.4 Dispenser.

Board Cross-Reference

USI

Topic section „Electronics Gen. 3“, chapter „USI board“,

Circuit diagrams for signal inputs  on page 23

Topic section „Applicator Interface“, chapter „Interface descripti-

on“, Circuit diagrams for signal inputs  on page 19

I/O

Topic section „Service Electronics“, chapter „I/O board“,

Input/Output Signals  on page 19

[Tab. 3] Topic sections with information about connecting the signal sources to be found in the service ma-

nual of the appropriate printer.

1 2 3 4 5 6 7 8 9 10 11 ... 44 45

No comments

Avery Dennison AP5.4 Gen II User Manual Page 6