Avery Dennison Label Printer Instruction Manual download pdf (Page 32)

4-4 Operator's Handbook

Using a High Energy Ribbon

High energy ribbon is an option for this printer. It enables you to print on high energy

(TUFF-MARK®) supplies.

When you select high energy ribbon for the printer setting, you are setting the printer to a

higher printing temperature. Select this setting only after you have loaded a high energy

ribbon and supplies or it may damage the printhead.

Note: The high energy setting is lost when you turn off the printer; select a high energy

ribbon every time you turn on the printer.

High Energy Ribbon Limitations

When using the high energy ribbon option:

 Use a print speed of 2.5 ips (inches per second).

 Printhead warranty is reduced to 100,000 inches.

 Serial bar codes cannot be printed.

 Do not use peel mode.

 No more than 20% of the supply should have print (black coverage).

CAUTION: The high energy ribbon may break or stick to the supply when more than

20% of the supply contains print.

 Only white high energy supply should be used for bar code printing.

 Reverse fonts cannot be used.

 A non-printing area of at least .1 inch (2.54 mm) must exist on the left and right edge

of the ribbon.

 Do not print horizontal lines or bars.

 Graphics are limited.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

No comments

Avery Dennison Label Printer Instruction Manual Page 32