Avery Dennison Label Printer Instruction Manual download pdf (Page 78)

Using RFID Supplies

RFID supplies are available in a variety of sizes. Refer to the 9906 RFID Setup Guide &

Supply Chart for more information.

Do not modify the Supply Position when using RFID supplies with greater than a

two-inch feed length. Doing so may move the RFID tag out of the RF Field’s readable

and programmable range. If necessary, you can modify the Print Position; however,

make sure you do not move the tag out of the readable and programmable range.

Using the RFID Setup Menu

Use the RFID Setup Menu to Read a tag, set the RF Power, and Clear Data.

Read Tag

Use this option to read the EPC data programmed into an RFID tag. You cannot read the

user memory data.

To read a tag, from the Main Menu, select Setup, then RFID. Then follow these steps.

1. Press  or  until you see

← Read Tag →

ENTER BACK

RFID

2. La

y the RFID tag you just programmed inside the supply path with the tag’s antenna

over the printer’s box antenna (the box antenna is located behind the platen roller).

3. Press ENTER.

8-2 Operator's Handbook

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 115 116

No comments

Avery Dennison Label Printer Instruction Manual Page 78