Setting the Stop Bits
A stop bit follows the data and parity bits to signal the end of a character.
To access this setting, from the Main Menu select Setup, Serial Comm. Then, follow
these steps.
1. Press or until you see Stop bits.
2. Press CHANGE to highlight the stop bit options. The current setting is shown.
3. Press or to scroll through the desired stop bits options.
1
CHANGE BACK
SERIAL COMM
Stop bits
← 1 →
SET CANCEL
SERIAL COMM
← Stop bits →
4. W
hen you see the stop bits option you need, press SET to save the change. Press
CANCEL to leave the stop bits unchanged.
5. Press BACK until you return to the Home/Online screen.
1
CHANGE BACK
SERIAL COMM
← Stop bits →
5-4 Operator's Handbook
Comments to this Manuals