Avery Dennison SNAP 600 User Manual download pdf (Page 39)

User’s Manual—SNAP™ 600 Printer

Figure 13. Print Head Components

4.1.2 Adjusting Density (Darkness)

The contrast knob for adjusting print density (darkness) is located between the

two print head pressure buttons (see Figure 13). You may adjust the contrast

knob while printing labels.

The nominal contrast setting is in the center of the rotation.

1. To increase print density, rotate the contrast knob clockwise.

2. To decrease print density, rotate the contrast knob counterclockwise.

You can manually rotate the contrast knob 270 degrees. At maximum value, the

print will not become any darker. In fact, it may actually begin to get lighter.

4.2 Adjusting the Stacker

The stacker on your AVERY DENNISON SNAP 600 printer is adjustable in four

ways: the position of the stacker on the mounting pins, the height of the stack,

the angle at which labels are accumulated in the stack, and the angle of the

platform. Different settings of these adjustments may be needed depending on

the length and width of the labels being printed and the material being used.

There are no incorrect settings, only adjustments that allow the stacker to better

accommodate the size and type of material used for the label being printed and

stacked. You will soon learn the settings that work best for your labels.

Print Head Pressure

Buttons

Contrast Knob

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 140 141

No comments

Avery Dennison SNAP 600 User Manual Page 39