86
User’s Manual—SNAP™ 600 Printer
4. Instructions for Factory / Field Installation of Top
Reflective Sensor 590013(F)
Installation Procedure
1. Disconnect Power to Printer.
2. Disconnect Stacker Interface Cable & Remote Display Panel (if so
equipped).
3. Remove the Rear Cover (save screws).
4. Remove ¼-20 Phillips Head Screw located on the back of the Upright
Frame closest to the Supply Unwind & just above the smaller Power
Supply
5. Remove the Turn Bar from the Web Guide Bracket & replace with the Bar
supplied with the kit as shown in Figure 1.
991374
PHILLIPS PAN HEAD SCREW
584024
SHAFT, WEB GUIDE (SENSOR)
581128
SENSOR
989975
4-40 X 3/16 PAN HEAD SCREW
Figure 1
6. Hold the Bar with the through hole in a vertical position. Reassemble
Step 4. ¼-20 Screw & secure. Be sure Web Guide Slides smoothly on Bar.
7. Assemble Harnessed Sensor into the through hole front the top & secure
with the 4-40 Screw in the inside hole in the Turn Bar. See Figure 1.
8. Insert the Connector / Lead through the Upright Frame behind the Web
Guide Knob and connect to connector marked “Top Reflective Sensor” in
MCB Board.
9. Reinstall Cover from Step 3.
Comments to this Manuals