Avery Dennison SNAP 600 User Manual download pdf (Page 71)

User’s Manual—SNAP™ 600 Printer

10.4 Cut / Stack

Problem Probable Cause Corrective Action

Machine fails to cut

labels (the rotary

knife does not rotate).

1) The knife is disabled. 1) Enable the knife in the setup menu via the

Remote Control / Display Module section

7.0, or through the Virtual Control / Display

in PCMate Platinum section 8.0.

2) Cut count is set to “0” in the

Design File.

1) Refer to the PCMate Platinum software

manual.

The stacker platform

fails to run.

1) The stacker cable is

disconnected.

1) Power off the machine and insert the

stacker cable in the stacker port.

Labels will not stack. 1) Stacker is not operating. 1) Be sure the nip roller is free to rotate.

2) Stacker position on the

machine too high or too low.

1) Move the toggle switch to the opposite

position.

3) Incorrect position platform bed

angle.

1) Use the pull pin to change the platform

angle.

Knife does not cut

completely through.

1) Knife blade shear is

misaligned.

1) Refer to section 6.4, Knife Shear

Adjustment.

Knife will not cut. 1) Knife blades are dull. 1) Refer to section 5.4.1, Removing and

Replacing the Knife assembly.

IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT

RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL

AVERY DENNISON REPRESENTATIVE.



1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 140 141

No comments

Avery Dennison SNAP 600 User Manual Page 71